Cart
| Code | 671267 | Type | Picosecond Laser | |
| Operating Wavelength | 1064nm | Output Power | 30W @ 1MHz | |
| Single Pulse Energy |
> 30μJ @ 1MHz | Repetition Rate | 1Hz – 2000kHz | |
| Pulse Duration |
< 15ps |
Beam Mode | TEM₀₀ | |
| M² Factor |
< 1.3 |
Beam Diameter | 1.0 ± 0.2mm | |
| Power Stability |
< 3% RMS over 8 hours |
Pulse Stability | < 3% RMS over 10 minutes | |
| Beam Divergence (Full Angle) | < 2 mrad |
Trigger Modes | Ethernet, Gate, Trigger | |
| Cooling Method | Water-cooled | Polarization Ratio | > 100:1 | |
| Polarization Direction | Vertical | Operating Temperature | 15°C – 35°C | |
| Operating Humidity | 10% – 80% (non-condensing) | Warm-Up Time | > 50 minutes |
Compatible with LBTEK Five-Axis Stainless Steel Fiber Stages FCSS-L5 / FCSS-R5
Precision Zirconia V-Groove Structure – designed for clamping fibers with diameters Ø125 μm – Ø280 μm and Ø150 μm – Ø341 μm
Soft Polyurethane Clamping Strip – provides excellent protection for fibers during clamping
The LBTEK FSV2 Fiber Holder is designed for mounting fibers onto the FCSS-5 series five-axis stainless-steel fiber positioning stages for precision alignment. The holder gently secures the fiber in a precision V-groove, with side screws used for tightening and locking the fiber in place. The bottom of the holder features a matching V-groove that fits directly onto the five-axis stage, ensuring accurate positioning. Additionally, the base has an M4 threaded hole, allowing direct mounting onto optical posts if needed.
Product evaluation
%High praise
There are comments